Inspection of side channel blower before use
Before we use the side channel blower equipment, we need to do some inspection work to facilitate our follow-up work. Often many people do not pay attention to this problem when using the side channel blower equipment, which leads to some failures before the equipment enters the formal work. Of course, these faults will aggravate and cause serious consequences when using.
Before operating the side channel blower equipment, if the fan has a major fault, it may also threaten the personal safety of the operator, so the safety awareness must be strong. Although there is no such thing, many major accidents are often caused by small details, and it is not afraid to be afraid of ten thousand. If it's a small fault, it's OK. At most, the fan is broken, which will not have any impact on the operators. The maintenance cost of the fan is higher.
Before using the side channel blower equipment, we need to check whether the bottom bolt is fully fixed, especially to check whether there is inclination. If there is inclination, it must be corrected in time. In addition, we need to see if there are some sundries attached to the bottom of the bolt. Because it is at the bottom, it is more likely to be contaminated, which will affect the work efficiency. In addition, we should take a look at the maximum load of the side channel blower, and adjust its mode according to its maximum load.
When adjusting the potentiometer of the side channel blower, we must pay attention to safety to ensure that all the power supplies are turned off. For safety, it is recommended to wear insulated gloves. (note that if the side channel blower needs to be removed, the power supply must be cut off and insulating gloves must be worn.
Dereike Intelligent M&E Equipment
Our's main products:Side channel blower,Turbo blower,High speed blower,Belt drive type blower,Ring blower,Anti-explosion blower,air knife,air filter,vaccum filter,muffler,pressure relief valve.etc.
